I bought a Belkin F5D7132 for $40 bucks on newegg. I was going to buy another Netgear WGPS606, but they are suddenly $80 which is insane.
I use the gear to hookup crusty PC types to my spiffy wifi.
Of course the WGPS606 also does the print server thing and has 4 ports. The Belkin has 1 port and seems to be really cheaply constructed.
I know I don’t really care about cheap construction either as long as it gets the job done… but 1 port? Really? Come on…
Get the fckr ready
OK, according to the manual that should really be “2661/237” seconds, but for me it’s easier just to convert it to digital… If you are slack you could just hold it for 10 seconds. Or you could tuffen up a bit… Your call. You know your own life better than I do.
Connect to it
It has a little web interface. It’s ip is 192.168.2.254
Sometimes it acts kind of like a dumbass and you may have to reset it again.
This may cause some teeth gnashing so throw something across the room, beat
the dog other inappropriate thing you do to vent rage.
Eventually you will see something like:
Set the password
Click on “Basic” on the left hand side and it will ask you for the password.
It tells you to hit submit if you haven’t set it, so click “submit” like
the champion of clicking “submit” you are. Really go nuts with it!
It will show you a screen with a bunch of stuff to ignore.
Click on the “System Settings” link on the bottom left-hand side.
Use your mad skills to figure out where to put your password…
HINT: “Type in new Password” and “Confirm new Password” worked for me.
Click “Apply Changes”
Logout and login again to make sure it is all kosher.
Hook up to yer network
OK! Time to click on “Basic”! Sweet!
Click on “Site Survey” and screw on the antenna. It may have picked up your
network without it, but if not, click “refresh”
Click the “Select Network” for you network and you will be rewarded with a
scary looking:
Then fear the wrath of:
Somehow I missed the chance to set the PSK, whatever… once it rebooted,
I connect to it again clicked on “Security” and set it.
Click “Apply Changes”
The end
Finally, I click the “Network Manager” on my laptop and tell it to use
“Wired Network” and it does it:
ifconfig eth0 eth0 Link encap:Ethernet HWaddr 00:16:41:16:83:A2 inet addr:192.168.69.100 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:6847 errors:0 dropped:0 overruns:0 frame:0 TX packets:7073 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:6048751 (5.7 MB) TX bytes:742450 (725.0 KB) Interrupt:16
ta-freakin-da!
thank me
This page brought to you by the editor “vim” and the search and replaces:
:%s,^#\(.*\),
\1
:s,.*,BTW… Irritated by the pointless war in Iraq? Miffed by outrageous gas prices?! Don’t blame me! I voted for porkchops!